Kanzashi hairpin

We always want to come up with something unusual for our child for any holiday. So that both the outfit and all sorts of accessories for it are combined very beautifully. Every mother especially carefully selects jewelry for her princess. To come up with something exclusive, this master class will help us.

DIY kanzashi hairpin


As a result, we will get such a beautiful brooch as in the photo. What kind of materials do we need for this:
• A wide blue satin ribbon, 4-5 cm wide, approximately 0.5 meters will be needed;
• Satin pink and white ribbons, the width of the ribbons is 2.5 cm, and the length is about 25 cm each;
• Blue acrylic cabochon;
• Preparation of a hair clip;
• Scissors;
• Glue gun;
• Lighter;
• Ruler;
• Pencil;
• White thread and needle;
• Tweezers.

materials for hairpins


So let's get started. We take satin ribbons, a ruler, a pencil and scissors. We will measure out the base squares for the petals. From blue tape we measure squares measuring 5*5 cm, and from pink and white tape we measure 2.5*2.5 cm. We cut approximately 10 to 15 squares of each color. It all depends on how many petals you want in your flower.

satin ribbons

cut into squares


Now take a lighter and burn all the squares with it. The bases for the petals are ready.

melt the edges


Take the blue square and fold it diagonally.

melt the edges of everyone

take the blue kradratik


Now we fold it diagonally again and so on a third time.

fold in half

fold diagonally


We take tweezers, insert the petal into it and cut it off from the bottom and side with sharp scissors. Use a lighter to follow the cut edges.

fold diagonally

cut off


We straighten the petal. Now take the pink square and fold it diagonally.

cut and melt

Straightening the petal


Then fold it again. It turns out not three, but two times. And also fold the white square twice.

take the pink square

fold a square diagonally


We place the white square 2-3 mm lower than the pink petal and fold them together again. The petal turns out to be thick, so it is better to immediately take it with tweezers. Cut off the bottom and one edge with scissors.

twice and a white square

We apply a white square


We burn the cut edges with a lighter. Unfold and straighten the petal. Thus, we get a white-pink double petal, only it is half the size of the blue petal.

Cutting with scissors

Cut edges


We make the required number of both petals in this order. Now, using a glue gun, we glue in the white and pink blue petals, and we get a flower petal like the one in the photo.

burn with a lighter

We do it in this order


I get a flower from ten such petals, so we make ten accordingly. Then we sew them together with a thread and a needle, forming a flower. Now we cut a small square from the blue ribbon, then round it and process it with a lighter. This circle will be the bottom of the flower. We turn the flower over and glue the backing with a gun.

ten such petals

forming a flower


The bottom of the flower is ready, turn it over and glue a blue cabochon in the center.

petals

glue a blue cabochon in the center


All we have to do is glue the flower onto the clip and we're done. This is how we independently made an accessory that will perfectly complement any little princess’ dress. Thank you all so much and good luck in the process!

kanzashi hairpin is ready

Attach a hairpin

kanzashi hairpin
come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
4 minus one =
Comments (0)