How to make a soldering nozzle for a gas torch

Soldering sometimes has to be done in places without an electrical outlet within reach. In this case, you can make a special nozzle for the gas burner. With it, electricity is not required for soldering.

Materials

  • A tube;
  • blank for turning;
  • copper or brass rod 4-8 mm;
  • M3 screws – 2 pcs.

Nozzle manufacturing process

A pipe section of 70-100 mm needs to be trimmed evenly and perforations made in it, leaving a quarter of the length intact.

For this, a tube is used that can fit tightly onto an existing gas burner.

A plug is machined from a metal blank for a tube with a hole in the center for inserting a soldering iron tip.

On the side it is drilled in two places for threading.

This is necessary to screw the plug to the perforated tube, and at the same time press the tip in the center.

By installing this nozzle on the burner, you can heat its tip with a flame.

The result is a soldering iron that is completely independent of the mains. The heating power is regulated by the gas supply, as well as by the projection of the tip.

Watch the video

come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
5+two=
Comments (0)