Battery replacement plus possible modding

Recently I came across a rather interesting Chinese tablet. According to the owner, after turning on the tablet, it works for a maximum of 5 seconds and turns off. It was decided to disassemble the tablet and see what was causing the problem.
Here is the tablet itself.

Battery replacement plus possible modding


Standard set: 1.2 GHz processor, 512 MB RAM, on board Android version 4.0, 7-inch screen. I was also surprised by the presence of a full-fledged USB host port. In general, the tablet is assembled quite well.
So, let's start the autopsy.
There are two bolts located on the side of all connectors and inputs. They need to be unscrewed.



Next, you need to unfasten the latches along the perimeter of the case. I did this with a sharp knife. But be careful. As it turned out, there are cables running there literally a few millimeters from the latches; do not cut them.




And here's what was inside.



All cables, connectors, etc. were checked. Then the charging controller rang. It turned out to be correct. As for the battery, it was not difficult to press it with your finger. It looks like liquid was poured into a plastic bag. After desoldering and laborious unsticking of the battery, this is what happened.



There was more than enough space for the new battery.



After googling a bit, I came across a suitable battery. Both in size and dimensions.
What can I say, the battery fit perfectly, as if there was a place for it. Instead of the previous 1800, we now have 3600 milliamps per hour. Profit x2! This is what the device looks like with a new battery.



Since the tablet was disassembled, thoughts arose to tweak something else. And a great idea came to mind. The tablet has a front camera for video calls, but it can also just take photos.
Here's the camera. Inside view.



The camera is connected using a flexible cable. By carefully bending it, you can turn the camera in the opposite direction, i.e. Push. From the front camera, it turns into a regular rear camera.



However, to do this you need to drill a hole in the back cover. But because The tablet is not mine, so I have no right to spoil the appearance.
Contact pads and a cutout in the PCB were also discovered. Most likely, just for the rear camera.



It is probably present in more expensive models.
Putting the tablet back together. We close the latches. We tighten the screws. And we check.
Voila!




The tablet works! In active use mode, it lasted 4 hours.
come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
3+three=
Comments (12)
  1. Denchik
    #1 Denchik Guests 17 March 2013 14:03
    0
    Useless homemade product :fellow:
  2. Basil
    #2 Basil Guests 27 March 2013 15:10
    1
    The photo shows different devices
    in the fifth photo there are 4 memory banks soldered in, on all the others there are 2, how is that?)
  3. Dima Smirnov
    #3 Dima Smirnov Guests 27 March 2013 19:39
    0
    While changing the battery, this fool decided to get rid of the memory))
  4. Basil
    #4 Basil Guests 5 April 2013 14:55
    0
    and the wire was gray, became black wink
  5. Basil
    #5 Basil Guests 8 April 2013 15:38
    0
    and the board has changed completely))
  6. Serj
    #6 Serj Guests 17 July 2013 20:35
    0
    Well, you are stupid, this is a bad photo..
  7. iZverg
    #7 iZverg Guests 25 September 2013 23:13
    0
    The tablet is not a Wexler, is it?
  8. Leonid
    #8 Leonid Guests 1 November 2013 20:13
    1
    I have the same unit, although it’s a little newer and has a rear camera. I don’t recommend opening it with a knife, but whichever plastic card is just right. However, if you get the hang of it, then on the opposite side of the buttons, it can be easily opened with a nail 1-1.2 mm long. I REALLY WANT TO KNOW FROM THE AUTHOR OF THIS REPORT. What resources did he use to find out? detect a current battery with such a good resource?
  9. Sanya
    #9 Sanya Guests 5 January 2014 17:17
    0
    Google will save the father of Russian democracy!
  10. Gleb
    #10 Gleb Guests August 21, 2014 08:57
    0
    The most USELESS homemade product!!!! :crying: