Flash drive case in LEGO style

Sometimes there comes a time in the life of a flash drive when its casing begins to break. Unfortunately, this situation happened to me too. Everything would be fine, but the lack of a housing on a flash drive often leads to a shortened life or complete failure of the device. At first there was an option to wrap everything with tape or tape, but many flash drives heat up during operation, and the glue of these tapes is not heat-resistant. And suddenly the idea occurred to me not only to protect the device, but also to provide a creative look. So let's get started!

We will need:
* several LEGO bricks and plates for them
* candle or lighter for heating the tool
* matches
* knife (or medical scalpel)
* fine sandpaper on a block
* flash drive (preferably small)
* super glue based on cyanoacrylate (can be bought at a hardware store)
* remains of the previous building (if necessary)
* gloves (to protect against glue)

Materials


First you need to prepare a cube. If your flash drive is small, then you can use a 4X2 block; if it’s simple, then you’ll have to select another cube. Next, use a hot knife to make a neat hole for the USB connector.

Cutting a hole


It should be no larger and no smaller than the connector, otherwise the product will look ugly and the flash drive will dangle in the case.

Finished hole


Through the hole we cut out some of the insides of the LEGO block so that there is room inside for the flash. If possible, you can finish it with a file, but do not process the product together with a flash drive, because this threatens to break the entire device.

preparing the place for the connector

removing waste from the cube


Afterwards, insert the flash drive into the cube and glue the plate into the bottom of the cube with a small amount of cyacrine to close the product.

Insert the flash drive into the new case


If the flash drive is flat and falls into the USB port, then you can glue a lining from parts of the old case.

Cutting out the lining from the old case

Glue the lining


That's all! The creative flash drive is ready!

Ready product

Flash drive case in LEGO style
come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
4 minus one =
Comments (1)
  1. Keeler in sneakers
    #1 Keeler in sneakers Guests 3 September 2013 14:18
    2
    it's a little scary...