How to make a rip fence cutter

When working with many soft sheet materials, trimming is usually done with a straight edge knife. Without proper skill, such a cut turns out to be curved, since the blade does not enter the material at a right angle. As a result, a wave is noticeable at the end of the trim. It is much better and faster to cut with a cutter with a rip fence, which can be assembled in literally 10 minutes. With its help, it is easy to cut into strips or trim veneer, plastic lining, ceiling tiles, polystyrene foam, drywall and much more.
How to make a rip fence cutter

Materials:


  • replaceable blade for scalpel cutter;
  • wooden slats;
  • mounting perforated corners – 2 pcs.;
  • short screws;
  • tin or sheet metal.

How to make a rip fence cutter

Making a cutter


Assembling the cutter should begin by preparing 2 short slats, which will serve as a parallel stop and a mechanism for adjusting the width of the cut. Ideally, one of them will be narrower, which will make the tool lighter. The optimal length of a wide rail is 15 cm, and a narrow one is 10 cm.
How to make a rip fence cutter

Next you need to trim the mounting corners. Their sides are cut to the height of a narrow strip. This is not necessary, but with shortened corners the tool will look more compact and neat.
How to make a rip fence cutter

In order for the cutter to have a pleasant appearance, glide well and not leave splinters, it is necessary to sand the slats, at the same time rounding off the sharp edges. If their sides are not completely parallel, this can be corrected by sanding. Next we will paint.
How to make a rip fence cutter

You need to screw a plate made of tin or any sheet metal to the end of the narrow rail with 2 self-tapping screws. It is important that the distance between the screws allows you to insert a scalpel blade under the plate.
How to make a rip fence cutter

Then you also need to screw the cut corners onto the wide rail using self-tapping screws. Their task is to clamp a narrow bar between them so that it is located at a right angle relative to the second one.
How to make a rip fence cutter

Next, the blade is inserted under the plate and positioned in such a way that its tip, when the instrument is laid on the table, reaches the table top. After this, its position is fixed by tightening the screws.
How to make a rip fence cutter

How to make a rip fence cutter

To use the cutter, you need to extend its rack with the blade to the length to which you want to cut. After this, the tool is applied close to the material and pulled towards itself. In this case, you need to try to ensure that the thrust bar is constantly pressed. In this case, you are guaranteed to get a perfect parallel cut.
How to make a rip fence cutter

How to make a rip fence cutter

How to make a rip fence cutter

How to make a rip fence cutter

How to make a rip fence cutter

Watch the video


Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
3+three=
Comments (0)