Spinner from RAM
I probably know everything about him, from small to large. Can be bought almost anywhere. Grocery stores, stalls. What can we say about hypermarkets and supermarkets.
I decided to keep up with everyone’s enthusiasm and created my own design.
I have an old motherboard lying around, and on it...
To make a spinner we will need:
- RAM, the same one from the old motherboard;
- bearing;
- feather drill and drill;
- needle file.
The first step is to unsolder the microcircuits in the center of our RAM. You can desolder without sparing the microcircuits. You can start by cutting off the legs and then soldering off the rest.
I removed the bearing from the old fan. Diameter 16 mm. Screwed it onto the screw. I inserted it into the drill and, turning it, washed it in kerosene. Then I lubricated it with Teflon grease and left it to wait its time.
In the center of the RAM I drilled a hole with a 12 mm feather drill and adjusted it to 16 mm with a needle file. Having previously screwed the two strips together. This is how they acquired rigidity and did not move during doping.
When the hole is adjusted, take the bearing and carefully drive it into the strips.
After installing the bearing, I fixed the nuts on the screws with super glue.
The spinner is ready. Now you can twist it as much as you like.
I decided to keep up with everyone’s enthusiasm and created my own design.
I have an old motherboard lying around, and on it...
To make a spinner we will need:
- RAM, the same one from the old motherboard;
- bearing;
- feather drill and drill;
- needle file.
The first step is to unsolder the microcircuits in the center of our RAM. You can desolder without sparing the microcircuits. You can start by cutting off the legs and then soldering off the rest.
I removed the bearing from the old fan. Diameter 16 mm. Screwed it onto the screw. I inserted it into the drill and, turning it, washed it in kerosene. Then I lubricated it with Teflon grease and left it to wait its time.
In the center of the RAM I drilled a hole with a 12 mm feather drill and adjusted it to 16 mm with a needle file. Having previously screwed the two strips together. This is how they acquired rigidity and did not move during doping.
When the hole is adjusted, take the bearing and carefully drive it into the strips.
After installing the bearing, I fixed the nuts on the screws with super glue.
The spinner is ready. Now you can twist it as much as you like.
Similar master classes
Particularly interesting
Comments (0)