How to quickly remove a stump on a site without uprooting and saltpeter
How to quickly remove a stump on a property
We begin work by digging in a tree stump to a depth of no more than 15 cm and a diameter of up to 100 cm. Then we wash the stump in any accessible way, for example, with a car wash device.
This is necessary in order to remove small stones, dirt and dust from the stump, since in the future you will have to use a chainsaw. This will protect the expensive saw chain from damage.
Next, using a chainsaw, we cut the stump in a horizontal plane at the maximum possible depth along almost its entire cross-section.
The next operation to remove a stump is to cut it in a vertical plane along its diameter to a horizontal cut.
As a result of these two cuts, the stump practically falls apart into halves, which are physically easy to remove without any problems. If one of the halves is not completely trimmed in a horizontal plane, then we finish it outside the stump.
The surface of the stump after the measures taken is 10 centimeters below the surface of the earth.The part of the stump remaining in the ground will gradually rot, and to prevent sprouts from the stump from coming out in the future, we fill the stump remaining in the ground with one or two packs of ordinary table salt. Now all that remains is to fill the depression with earth, level and compact the surface. Stump like never before.
