Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

If you often have to weld profile pipes, then in order to speed up the process as much as possible and achieve precise observance of the right angle, it is worth making the following device. When using it, the pipes will not resist welding, so every connection will be perfect.

Materials:


  • profile pipes;
  • corner;
  • brake shoe;
  • Sheet steel;
  • regular and extended M10 nuts;
  • M10 stud.

Manufacturing process


It is necessary to weld a section of profile pipe to the brake pad as in the photo.
Convenient brake shoe attachment for welding pipes at right angles

A square base for the fixture is then cut from sheet steel. Its size depends on the block used, but in most cases 40x40 cm, or even less, is sufficient.
Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

2 stops are welded to the base from one corner. These can be corners or a profile pipe cut lengthwise. It is important that there are 90 degrees between them. The stops are welded with a gap in the corner.
Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

Next you need to make a clamp. It consists of a stud screwed into nuts, which are welded to the base through a spacer. The heel is located diagonally relative to the sole.
Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

At the point where it rests on the block profile, you need to cut out the wall so that the pin does not slide. On the reverse side, a knob is made on it.
Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

To use the device, you need to install 2 pipes under its stops and press them with a block by screwing in the pin. The workpieces clamped in this way will not move during welding, and the angle between them will be strictly 90 degrees.
Convenient brake shoe attachment for welding pipes at right angles

Convenient brake shoe attachment for welding pipes at right angles

Watch the video


come back
Comment
  • bowtiesmilelaughingblushsmileyrelaxed relaxedsmirk
    heart_eyeskissing_heartkissing_closed_eyesflushedrelievedsatisfiedgrin
    winkstuck_out_tongue_winking_eyestuck_out_tongue_closed_eyesgrinningkissingstuck_out_tonguesleeping
    worriedfrowninganguishedopen_mouthgrimacingconfusedhushed
    expressionlessunamusedsweat_smilesweatdisappointed_relievedwearypassive
    disappointedconfoundedfearfulcold_sweatperseverecrysob
    joyastonishedscreamtired_faceangryragetriumph
    sleepyyummasksunglassesdizzy_faceimpsmiling_imp
    neutral_faceno_mouthinnocent
5+two=
Comments (0)